Broken glass is a safety job — we prioritise it
Shower Screen Glass Replacement Sydney
Cracked, chipped or shattered glass? In most bathrooms we take out the broken panel and fit a new one. The frame, the door hardware and the rest of the screen stay right where they are.
If the glass has already shattered, do this first
- 1Keep everyone out of the bathroom. Bare feet and pets first.
- 2Do not pull at the leftover glass. A broken panel often keeps dropping pieces for hours.
- 3Take one photo from the doorway. That is enough for us to price it.
- 4If pieces are still falling, lay an old towel along the base to catch them.
- 5Ring us. We clear the glass and board the opening if this is your only bathroom.
Can you replace just one panel?
Yes. On most Sydney shower screens, a single cracked or chipped panel comes out on its own and a new one goes back in. You rarely need a whole new screen. The new piece is measured at your place and cut to fit, so the job normally takes two visits a few days apart.
Cracked, chipped or shattered — which one is yours?
How a single panel swap works
Why toughened glass breaks the way it does
What thickness of glass will you get?
Bars shown to relative scale.
Why it takes two visits
What changes the price
- Thickness. A 10mm frameless panel costs a good deal more than a 6mm one of the same size.
- Size. Taller than about 2100mm and the panel needs two people to lift and fit.
- Holes and cut-outs. Hinge cut-outs and handle holes are all done before toughening, so they add to the piece.
- Door or fixed panel. A door takes longer, because the hardware has to come off and go back on square.
- Access. A ground-floor bathroom is simpler than a third-floor unit with a tight stairwell.
Where we replace shower glass
Common questions
No. A crack in toughened glass cannot be filled, glued or polished out. The strength of the panel comes from tension held inside the glass, and once that is broken the piece has to come out. The good news is that only the broken piece needs to go. Everything around it stays.
We would not. A cracked panel can hold for weeks and then let go without warning, usually when the door is knocked or the room heats up. If it is the only shower in the house, use it carefully, keep children and pets out, and get it looked at quickly. If there is another bathroom, use that one until the glass is changed.
Almost always there was damage first, usually a small chip on an edge or corner that nobody noticed, and the panel finally gave way days or weeks later. Heat changes in the room can be the final push. Very rarely a tiny flaw inside the glass causes it instead, which is a known fault in toughened glass and nothing you did.
Because toughened glass is cut and drilled before it is toughened, not after. Once a panel has been through that process it cannot be trimmed at all. Try it and the sheet breaks apart. So the measurement has to go to the glass works and the piece is made to your opening.
In a clear glass screen, yes. Clear toughened glass has a slight green tint in the edge and the new piece will have the same. Patterned or frosted glass is harder, because older patterns get discontinued. If we cannot match it we will say so before you commit, and then it becomes a choice between a close match and replacing more than one panel.
The measure takes about twenty minutes. The glass itself normally takes a few working days to be made. Fitting is around an hour for a fixed panel and a little longer for a door. If the panel has already shattered we clear the glass on the first visit so the bathroom is safe in the meantime.
Yes. Broken glass goes with us, including anything we clear out of the base and the channel. Nothing is left in your bin.
Sometimes, but it is worth thinking about. If the aluminium has gone chalky and soft at the base it will not hold a new panel properly, and you would be paying for glass that has to come out again later. In that case we would quote the frame at the same time, or talk about a new screen if both are past it.
Related glass work
On every glass job
- Grade A safety glass to AS 1288, stamped
- Measured at your place, cut to your opening
- Old glass taken away
- Licensed glaziers, fully insured